Preparation of fly ash-granulated blast furnace slag-carbide slag binder and application in total tailings paste backfill
Based on activation and synergistic effect among various materials,a low-cost mine backfill cementing material,FGC binder,was prepared by using fly ash,granulated blast-furnace slag(GBFS),carbide slag and composite activator.The proper proportioning of FGC binder is obtained by response surface experiment optimization method: fly ash 62%,GBFS 20%,carbide slag 8%and compound activators 10%.Adjusting the material ratio obtains different cementing material which could satisfy requirements of different mined-out areas.With the mass ratio of cementing material and tailings 1︰4~1︰8,the concentration of total solid 70%,the compressive strength values of total tailings filling body at 28 d reaches 1.64~4.14 MPa,and the backfilling cost is 20%lower than using OPC cement.
Chao Li Ya-fei Hao Feng-qing Zhao
Department of Chemical Engineering,Hebei University of Science & Technology,Shijiazhuang,050018,Chin Hebei Engineering Research Center of Solid Waste Utilization,Shijiazhuang,050000,China
国际会议
上海
英文
1-5
2017-12-28(万方平台首次上网日期,不代表论文的发表时间)