Intelligent Plantar Pressure Monitoring Insole Based on 3D Printing and Flexi Force Sensor Technology

摘要：

　　Using 3D printing and Flexi force sensor technology to measure the foot pressure of the body under different movement conditions, the plantar pressure distribution was mainly measured at the thumb, the first metatarsal, the fifth metatarsal and the heel.The results showed that the plantar pressure under different exercise conditions will change significantly.Thumb was first contact ground during running, followed by the forefoot and the heel, and the heel pressure is always the largest.During the upstairs and downstairs, the plantar pressure distribution will change with the movement of the gravity.When the person goes upstairs, the center of gravity moves forward.The pressure on the plantar forefoot is a bit more pressure than going downstairs,but the heel pressure increases dramatically when he goes downstairs,which explained people center of gravity is moving backwards during the downstairs.

关键词： 3D printing Flexi force sensor First metatarsal Fifth metatarsal

作者: Min Gao Yifan Zhang Chengyu Hong Xiuli Gao

作者单位: College of Textiles, Donghua University, Shanghai 201620, China;Engineering Research Center of Techn College of Textiles, Donghua University, Shanghai 201620, China;Engineering Research Center of Techn Department of Civil Engineering, Shanghai University, Shanghai 200444, China School of Textiles , Henan University of Engineering , Zhengzhou 450007, China

会议类型: 国际会议

会议名称: 2018 Sino-Africa International Symposium on Textiles and Apparel (SAISTA2018)(2018中非纺织服装国际论坛)

会议地点: 巴赫达尔

会议语种:英文

页码: 284-288

在线出版日期: 2018-09-15（万方平台首次上网日期，不代表论文的发表时间）