Study on forming process and spring back control of high strength sheet based on Dynaform

摘要：

　　The drawing process of a high strength steel part without blank holder force was numerically simulated based on Dynaform.In present investigation,the drawing velocity and velocity profile motion of punch was studied by simulating the drawing operation of high strength steel part.The results show that restricting drawing velocity and controlling velocity profile motion of punch could all reduce the spring back.The measure of restricting drawing velocity could reduce non-pressure forming spring back about 31%and Trapezoidal motion mode of punch is the most beneficial to reduce spring back.

作者: Liu cunping

作者单位: Yibin Vocational and Technical College,Department of Modern manufacturing,644003 Sichuan Province,China

会议类型: 国际会议

会议名称: 2018 2nd International Conference on Electronic Information Technology and Computer Engineering (EITCE 2018)(2018第二届电子信息技术与计算机工程国际会议)(EITCE2018)

会议地点: 上海

会议语种:英文

页码: 1-4

在线出版日期: 2018-10-12（万方平台首次上网日期，不代表论文的发表时间）