Experimental Study of Turning Temperature and Turning Vibration for the Tool of Different Wear State
By a vibration test device and VibSYS analysis system,a three-dimensional piezoelectric acceleration sensor and an infrared thermometer and its collection system,the turning experiments under different spindle speeds were carried out on three cutting tools with different wear states,and the change law of cutting temperature at the tool tip and change law of three-dimensional vibration with turning time were obtained.The results indicate that:(1)The temperature of the initial wear tool and the middle wear tool under a small turning parameter increased slowly with turning time; while under a greater turning parameter,the temperature of the middle wear tool varies significantly with time;(2)The temperature of the severe wear tool increased sharply at the later feeding stage;(3)The change laws of the tools vibration acceleration maximum with the spindle speeds are similar for the initial wear tool and the middle wear tool,which shows a trend of increasing at first and then decreasing;(4)the average value of vibration acceleration self-power spectrum of severe wear tool constantly increase with the spindle speed;(5)the maximum impact is along the radial direction for the tools of different wear state.
Shuncai Li Qiu Yu Guanlei Yuan Li Liang
JSNU-SPBPU Institute of Engineering,Jiangsu Normal University,Xuzhou Jiangsu 221116,China;School of School of Mechanical & Electrical Engineering,Jiangsu Normal University,Xuzhou Jiangsu 221116,China
国际会议
上海
英文
1-7
2017-12-28（万方平台首次上网日期，不代表论文的发表时间）