EVALUATION OF MEASUREMENT INTERCOMPARISONS(CCM.M-K5)BY MONTE CARLO METHOD

摘要：

　　The CCM key comparison CCM.M-K5 was performed during June 2002 to April 2003.It included five different nominal values like 2 kg,200 g,50 g,1g and 200 mg.Two weights were prepared for each nominal value for each set of transfer standard.Therefore,each set contains ten weights.However,two Key Comparison Reference Values(KCRV)for the same nominal value were supplied in the final report.This was quite different with CCM.M-K1,K2,K3,K4,K6 and K7.Because it is difficult to link Region Metrology Organization(RMO)Comparison result(like: APMP.M.M-K5)to CCM key comparison.This paper describes how the Monte Carlo method was used to evaluate CCM.M-K5 measurement results and KCRVs together with their uncertainties and degree of equivalence(DoEs)were given out.These results could be used in analysis and linking of international measurement comparisons between APMP.M.M-K5 and CCM.M-K5.

关键词： Key Comparison Reference Value Degree of Equivalence Monte Carlo Method

作者: X.P.Ren J.Wang X.L Wang S.Su D.Yang

作者单位: Department of S&T Management,National Institute of Metrology,100029,Beijing,P.R.China Division of Mechanics and Acoustics,National Institute of Metrology,100029,Beijing,P.R.China

会议类型: 国际会议

会议名称: 国际测量技术联合会(IMEKO)2017年国际测量技术研讨会

会议地点: 杭州

会议语种:英文

页码: 160-162

在线出版日期: 2017-09-04（万方平台首次上网日期，不代表论文的发表时间）