Experimental research onsynchronousmanufacturing technology for bliskusingdifferent polishing method
Blisk is an important component of aero-engine,and its surface quality can seriously affect their dynamic performance and fatigue life.However,it is difficult to polish the blisk at once,because of deep and narrowspace,free-form surfaces,easy deformation and interference,poor reach ability,difficult-to-cut materials,and so on,especially when polishing processes are required to ensure their compliance with strict industrial standards for bliskfull-area surface quality.Information on the available polishing processes for blisk is currently scarce.For this aims,two different polishing methods,called six-axis linkage belt polishingand robot wire-wheel polishing,are used in this paper.The experimental results show that the surface quality meets the manufacturing requirements when different methods are used for different areas of the blisk.It is proved that this method could be integrated to enable automated polishing of blisk full-area surfaces.
Blisk Belt polishing Wire-wheel polishing Six-axis linkage Robot
XIAO Gui Jian HUANG Yun ZOU Lai LIU Ying
The State Key Laboratory of Mechanical Transmissions,Chongqing University,Chongqing 400044,China
国际会议
第十七届国际制造会议(The 17th International Manufacturing Conference in China)(IMCC 2017))
深圳
英文
1-6
2017-11-23（万方平台首次上网日期，不代表论文的发表时间）