Flank wear of PVD TiAlN and TiAlCrN coated Ti(C,N)-Mo2C-Ni cermet inserts during turning 9CrSi2Mn steel

摘要：

　　The inserts composed of Ti(C,N)-10wt%Mo2C-15wt%Ni cermets(CM10)and WC-15wt%TiC-6wt%Co cemented carbides(YT15)were both coated with TiAlN and TiAlCrN films following physical vapor deposition(PVD),respectively.The cross-sectional morphology of the coated inserts was characterized by a scanning electron microscopy(SEM),and adhesivity of the coatings to the substrates was evaluated according to scratching.Flank-wear resistance of the coated inserts was analyzed when turning 9CrSi2Mn steel.It is found that TiAlN coating adheres to the cermet substrate more firmly than TiAlCrN.Additionally,the coated CM10 insert presents more excellent wear-resistance than the coated YT15 during turning,regardless of TiAlN or TiAlCrN.By contrast,TiAlN coating works better than TiAlCrN coating,especially in resisting against the adhesive wearing and diffusive wearing.However,obvious superiority of TiAlCrN coating over the TiAlN coating is exhibited as far as oxidative wearing.

关键词： TiAlN coating TiAlCrN coating Flank wear Cermet substrates Dry turning

作者: Yang Tian’en Xiong Ji Xiong Ji

作者单位: School of Manufacturing Science and Engineering,Sichuan University,Chengdu 610065,PR China

会议类型: 国际会议

会议名称: 第十七届国际制造会议(The 17th International Manufacturing Conference in China)(IMCC 2017))

会议地点: 深圳

会议语种:英文

页码: 1-9

在线出版日期: 2017-11-23（万方平台首次上网日期，不代表论文的发表时间）