SIMULATION OF SURFACE ACOUSTIC WAVE PROPAGATING CHARACTERISTICS IN RELAXOR BASED FERROELECTRIC SINGLE CRYSTALS POLED ALONG 011
The propagation characteristics of surface acoustic waves (SAWs) on Y-cut X propagating Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-xPbTiO3 (PIN-PMN-xPT) substrates with different PT composition (x=0.28 and 0.32) were theoretically analyzed.The calculated results indicated existence of a shear horizontal (SH) SAW with ultrahigh electromechanical coupling factor K2.The variation of SAWs properties with rotated Euler angle θ was also investigated.The largest K2 for the SH SAW could reach 60% when θ=45°.The K2 for the SH SAW with different PT contents was calculated, and it was found that the K2 for the 0.32PT substrate was larger than that for 0.28PT substrate.The influence of Mn-doping on SAW properties for YX-PIN-PMN-0.28PT substrate was also analyzed.The simulated results showed that after Mn-doping the velocity increased while the K2 decreased, which confirmed the phenomenon of hard effect caused by Mn-doping.
Relaxor ferroelectric single crystals SAW propagating Characteristics Large coupling factor
Jing CHEN Qiang XIAO Kai LIU Ping Cai Xiao-jun JI
School of Electronic Information and Electrical Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
国际会议
The 2017 Symposium on Piezoelectricity,Acoustic Waves and Device Applications(2017全国压电和声波理论及器件技术研讨会)
成都
英文
147-150
2017-10-27（万方平台首次上网日期，不代表论文的发表时间）