Teaching Practice of Numerical Control Machining Based on Boppps

摘要：

　　This paper introduces the reform in education of the engineer-training center.The BOPPPS model is applied to the teaching module of numerical control machining.The reform of education is carried out via chains such as general teaching design, pre-lecture, preview work, tests in class, active practice, programming simulation of industrial analysis, and summary.The practice has proved that the reform has achieved a good effect.

关键词： BOPPPS Teaching reform Teaching on numerical control machining

作者: ZHOU JIWEI FAN DAPENG WU ZHENGHONG WANG JIANMING LU YAOHUI

作者单位: College of Mechatronics Engineering and Automation, National University of Defense Technology, Changsha, Hunan, China

会议类型: 国际会议

会议名称: The 11th International Conference on Modern Industrial Training(第十一届现代工业培训国际学术会议)

会议地点: 北京

会议语种:英文

页码: 654-658

在线出版日期: 2015-10-23（万方平台首次上网日期，不代表论文的发表时间）