The Optimize Design of the Moulded Case Circuit Breaker Contact Based on ADAMS
In this paper the virtual prototyping technology was used to the design of circuit breaker.On analyzation of the disadvantage of traditional molded case circuit breaker, a new contact system according to the requirements of improving was established.the frame of traditional contact system was changed;the bounce of contact will not happen because of collision avoidance when switch on;switch off arc was eliminated automatically.The fabric is very simple and do not need to design arc chamber.the sliding force of two contacts will eliminate the oxide film.Apply ADAMS to the analysis of traditional contact and new contact, it saved time during design, also improve the efficiency and reduce the cost.Many useful dates were got by dynamic simulation.
low voltage circuit breaker contact system improving design
Weibei Zheng Xiuping Su
Hebei University of Technology, Tianjin, 300130, China;Hebei University of Science and Technology, S Hebei University of Technology, Tianjin, 300130, China;Electrical Apparatus Institute of Hebei Provi
国际会议
温州
英文
423-426
2014-11-16（万方平台首次上网日期，不代表论文的发表时间）