MACHINE OPTIMIZATION PROBLEM OF MULTIPLE PCB TYPES CONSIDERING NOZZLE FACTORS

摘要：

　　Allocation problems of printed circuit board (PCB) assembly are dealt with in this paper for single placement machine under high-mix low volume production environment with the consideration of nozzle factors.Assuming that component types are loaded at feeder rack by group strategy, the assembly time of placement machine consists of production time, automatic and manual nozzle setup time.The production time are determined by the component-nozzle allocation sub-problem and nozzle-head allocation sub-problem of each PCB type.The automatic and manual setup time are determined by the nozzleautomatic nozzle changer (ANC) allocation subproblem.Heuristic algorithms are proposed to solve these problems.In numerical analysis, the proposed method is compared with the upper bound, which shows its effectiveness.

关键词： Allocation problem PCB assembly nozzle factor multiple PCB types

作者: Shujuan Guo Katsuhiko Takahashi Katsumi Morikawa Pengjun Zheng

作者单位: Faculty of Maritime and Transportation, Ningbo University, Ningbo, 315211, China Graduate School of Engineering, Hiroshima University, Higashi Hiroshima,7398527, Japan

会议类型: 国际会议

会议名称: The 11th International Conference on Industrial Management(第十一届工业管理国际会议)

会议地点: 日本

会议语种:英文

页码: 236-241

在线出版日期: 2012-08-29（万方平台首次上网日期，不代表论文的发表时间）