CREEP STRENGTH BEHAVIOR OF BORON ADDED P91 STEEL AND ITS WELD IN THE TEMPERATURE RANGE OF 600-650℃
One of the promising ways for mitigation of Type IV cracking – a failure by cracking at the intercritical/fine grained heat affected zone,a life limiting problem in advanced 9–12 Cr ferritic steel weld like that of P91 is through modification of alloy composition by addition of boron.Addition of boron was observed to improve the microstructure at the weld zone and hence the creep strength.In the present work,boron(100 ppm with controlled nitrogen)added P91 steel after normalizing at 1050℃ and 1150℃ and tempered at 760℃ were studied for the creep behavior in the base metal and welded condition in the temperature range of 600–650℃.Creep strength was characterized in terms of stress and temperature dependence of creep rate and rupture time.Weld creep life was reduced compared to the base metal with rupture occurring at the ICHAZ(Type IV crack).However at longer time(at lower stress levels)exposure creep crack moves from weld metal to HAZ(Type II crack).Rupture life was found to superior for the base and weld in the boron containing steel when higher normalizing temperature is used.Estimation of 105 h was attempted based on short term rupture data available and weld strength factors were calculated.Observed values are better for P91BH condition than the values for P91BLcondition as well as those available for P91 in open literature.
Type Ⅳ cracking P91 steel Boron addition creep
J.Swaminathan C.R.Das Jayashree Baral C.Phaniraj R.N.Ghosh S.K.Albert A.K.Bhaduri
National Metallurgical Laboratory,Jamshedpur-831007,INDIA Indira Gandhi Centre for Atomic Research,Kalpakkam-603102 INDIA Indian Institute of Technology,Kharagpur-721302,India
国际会议
Energy Materials 2014(第一届能源材料国际会议)
西安
英文
111-121
2014-11-04（万方平台首次上网日期，不代表论文的发表时间）