Manufacture of Fabric Reinforced Thermoplastic Composites with High Fiber Volume Fraction

摘要：

　　In fiber reinforced thermosetting plastic (FRP) the fiber volume fraction is always up to 60 percent, but in fiber reinforced thermoplastic (FRTP) it is low to about 30 percent which greatly limit their performance.In this paper, for increasing the fiber volume fraction of thermoplastic composite, a new impregnation method for molding continuous fiber reinforced thermoplastic was explored; the fiber volume fraction was significantly raised to 60 percent which is equal to that of FRPs.Then the tensile property was investigated and made a contrast with FRP with the same reinforcement fiber.The results showed that both the FRP and FRTP composites have the similar tensile properties and indicated that the molding method is effective for FRTP manufacture.

关键词： fiber volume fraction continuous fiber reinforced thermoplastic mechanical test

作者: Anchang Xu Limin Bao

作者单位: Department of Bioscience and Textile Technology,Interdisciplinary Graduate School of Science and Tec Faculty of Textile Science and Technology,Shinshu University,3-15-1 Tokida,Ueda,Nagano 386-8567,Japa

会议类型: 国际会议

会议名称: The 8th China International Silk Conference (ISC2013)、The 4th Asian Protective Clothing Conference(APCC2013)and Eco-Friendly Textile Dyeing and Finishing Conference( 第八届中国国际丝绸会议、第四届亚洲防护服会议暨环保纺织染整会议)

会议地点: 苏州

会议语种:英文

页码: 301-305

在线出版日期: 2013-09-09（万方平台首次上网日期，不代表论文的发表时间）