会议专题

Investigation on the cutting force of high-speed milling of high volume fraction of SiCp//Al composites with PCD tools

  High-speed milling tests for 65vol.%SiCp/6063A1 composites were performed by polycrystalline diamond(PCD) tools, response surface methodology was utilized in this study, and a cutting force model was developed through response surface methodology, which contained some important parameters such as cutting speed, cutting feed rate, cutting depth and cutting width.The analysis of variance(ANOVA) indicated that the proposed mathematical model can adequately describe the relationship between cutting force and cutting process parameters.The results show that cutting depth is the biggest important factor of milling force, and cutting feed rate is the second important factor, cutting speed is the third; milling force would not increase with the increasing of cutting width.

High-speed milling 65vol. SiCp/6063Al composites PCD Response surface methodology Cutting force

Song Peng Li-jing Xie Xi-bin Wang Na-xin Fu Xing-kuan Shi

Key Laboratory of Fundamental Science for Advanced Machining, Beijing Institute of Technology, Beiji Beijing Institute of Radio Measurement, Beijing, 100854, China

国际会议

The Eighth China National Conference on Functional Materials and Applications(第八届中国功能材料及其应用学术会议)

哈尔滨

英文

350-360

2013-08-23(万方平台首次上网日期,不代表论文的发表时间)