Integrated Electricity And Heating Load Control Based On Smart Grid Technology
This paper aims at the difficulties in peak load supply and wind power integration with combined heat and power (CHP) widely used in North of China.Currently CHP units are excluded for electricity peak regulation and wind power is abandoned at the time of low electricity demand.In this paper,a method of integrated electricity and heating load control based on smart grid technology is proposed with introduction of electric heat pumps (EHPs) considering the heating delay due to heating distance.According to aforementioned methodologies,integrated electricity and heating load control is enabled: Firstly,in the electricity peak load or low wind power,heating water from CHP units is suggested to be shaved so as to increase its power output and reduce the peak of electricity load or compensate wind power equivalently; Secondly,taking account of heating delay due to heating distance,EHPs can supply heating by electricity to replace parts of CHPs heating water in the electricity valley load,so that the valley of electricity load is increased or excess wind power is utilized.At last,a numerical simulation concerning CHP,wind power turbines and condensing unit is performed to illustrate the result of this paper,it shows that the peak load can be cut equivalently and the capacity of integrated wind power is increased while the abandoned wind power is reduced.Moreover less energy consumption is realizable by this new method.
Combined heat and power smart grid electricity load wind power load control
Yulong YANG Hongyu LONG Kai WU Xu YAN Shuang XIA
State Key Laboratory of Electrical Insulation and Power Equipment,Xian Jiaotong University,Xian 71 Postdoctoral Workstation,Chongqing Electric Power Corporation,Chongqing 710061,China Northeast Agricultural University,Harbin 150030,China
国际会议
上海
英文
1-6
2012-09-05（万方平台首次上网日期，不代表论文的发表时间）