Optimization Design for Gun-receiver Materials Belt Grinding Based on Orthogonal Experimental Method and Grey Relational Analysis
In order to change the current situation of gun-receiver manual polishing,the paper presents a new process for abrasive belt grinding of gun-receiver material (C50 steel).Orthogonal test were conducted with abrasive belt grinding of C50 steel to do research on material removal rate and surface roughness.The best parameter combination to the optimization design which can guarantee high material removal rate and low surface roughness was obtained by using grey relational analysis method and verified by experiments.The above mentioned research not only can improve the removal rate of C50 steel,but also do help to prolong the service life of the belt.Whats more,it can guide a theoretical significance and practical value to the production practice.
abrasive belt grinding gun-receiver C50 steel orthogonal test grey relational analysis method
Yuhui Chen Yun Huang Yao Huang
The State Key Laboratory of Mechanical Transmission,P.R.China;Chongqing University,Chongqing,P.R.China;Chongqing Engineering Research Center for Material Surface Precision Machining and Whole Set Equipments,P.R.China
国际会议
杭州
英文
55-60
2013-09-23（万方平台首次上网日期，不代表论文的发表时间）