会议专题

Synthesis and photocatalytic properties of ZnO-Volcanics composites

  In this paper,nano-ZnO were synthesized via a sol-gel method,and ZnO-volcanics composites (ZVCs) were prepared via physical adsorption process.The morphology and structure of ZnO/ZnO-volcanics composites (ZVCs) samples were investigated by X-ray diffraction (XRD) and transmission electron microscopy (TEM).BET surface areas of the catalysts were determined by N2 adsorption (BET).According the data of XRD,the average grain size of ZnO is 15.1 nm consistent with the result observed by TEM (16.3 nm).Photocatalytic performance of ZnO and ZVCs were carried out in sprinkling photocatalytic reactor,with methylene blue (MB) as pollutants model.Decolorization rate is select as the evaluation parameters for the degradation effect.The effect of catalyst dosage,MB initial concentration,calcination temperature and pH on the degradation efficiency have been investigated.The MB degradation efficiency was 99.2% when the concentration of MB,the ZVCs,the pH and the calcination temperature were 10 mg/L,20 g/L,and 10.03,500 ℃ respectively.In the catalysts recycle experiments,the decoiorization rate of MB using ZVCs is 90.2% after utilization for six times,overwhelmingly higher than that of ZnO (22.6%),indicating immobilization is efficient.

ZnO-volcanics composites Sol-Gel method photocatalysis immobilization degradation

Wang Aihu Che Ping Liu Jiemin Wang Guihua

School of Chemistry and Biological Engineering,University of Science and Technology Beijing

国际会议

2013 International Conference on Process Equipment,Mechatronics Engineering and Material Science(2013过程装备,机电工程与材料科学国际学术会议)

武汉

英文

497-502

2013-06-15(万方平台首次上网日期,不代表论文的发表时间)