Research in optimization of inner-grooved copper tubes forming
By using the method of orthogonal design based on the inner-grooved copper tubes (Φ7.00×0.24),the influence in the different forming conditions was analyzed.The forming laws and optimization forming process parameters were also obtained during the experiment.The results show that the motor and drawing speed should be controlled about 23000r/min and 15rr/min respectively,and the spinning position should be located at about 1.5mm away from the center of the inner-grooved core head.
TP2 inner-grooved copper tube orthogonal design forming parameters optimization
Jinsong LIU Xinpeng WANG
Shenyang Ligong University, Shenyang 110159, China
国际会议
厦门
英文
591-594
2012-12-28（万方平台首次上网日期，不代表论文的发表时间）