会议专题

Modeling and Simulation of Hydraulic Turnover Device for Large Bearing House

  The geometric models of the hydraulic turnover device are constructed by using three -dimensional modeling software UG, and then they are induced into simulation software ADAMS by a sharing data format.By using ADAMS, models are further simplified and the virtual prototype is established.By using the associated model, the simulation of the hydraulic turnover device is analyzed in ADAMS.Compared with the traditional methods of using physical prototypes, the movement processes and relevant parameters of the hydraulic turnover device can be effectively obtained by means of this method.Furthermore, the quality of the constraint relations between the parts is very important in terms of the accuracy of the model simulation analysis.This simulation results accord with the practical situation, which indicates that the operation is stable and the efficiency is high.It provides a theoretical basis for the practical design of the hydraulic turnover device, which shows that the combination of ADAMS and UG works well.

Hydraulic turnover device Three-dimensional modeling Simulation analysis ADAMS

Xincai Zhu Lei Guo Youqing Ding Shunhong Lin

Chongqing University of Technology,Banan Borough 400054,Chongqing,China Chongqing University of Science & Technology,Shapingba Borough 401331,Chongqing,China

国际会议

the 2012 International Conference on Vibration, Structural Engineering and Measurement (2012年振动、结构工程与测量国际会议(ICVSEM2012))

上海

英文

660-664

2012-10-19(万方平台首次上网日期,不代表论文的发表时间)