会议专题

Research on Rules of the Roll-gap Fluctuation of the Typical Segment in Continuous Slab Casting

  Segments are key parts in continuous slab casting.They support all cast rolls,control thickness of the slab and lead during continuous casting machine when the shell leaves the mould.The fluctuation of roll gap that is caused by segments deformation and install error directly is one of the main factors influencing slab quality.Recent researches and publications have focused on cast rolls and slab when the roll gap has been investigated.However,the Segment or its frame has been ignored.This paper describes an investigation into the deformation and stress of the segment and roll-gap fluctuation using ANSYS and MARC software.A three-dimensional model including up-down frames,casting rollers,cylinders,ball bearings and muti-body contact between them has been constructed and applied to case studies.Four typical working conditions that no-load online caster,casting load based on ideal-design roll-gap,casting load and half load based on initial measured roll-gap are also discussed.The analysis produces outputs such as rules of the roll-gap fluctuation under different roll gaps.The indications are that the segment has excellent adaptive characteristic.Finally,the theoretical basis for the optimism design of roll-layout has been suggested.

continuous slab casting segment roll-gap fluctuation deformation

QIN Qin

School of Mechanical Engineering,University of Science and Technology Beijing,Beijing 100083,China

国际会议

Asia Steel International conference 2012(第五届亚洲钢铁大会)

北京

英文

1-5

2012-09-23(万方平台首次上网日期,不代表论文的发表时间)