Numerical Simulation of Cylinder Part Based on Dynaform

摘要：

　　The forming process of a typical cylinder part is simulated by the platform of Dynaform.The influence of blank holder force (BHF),punching speed and clearance between punch and die on the quality of forming part is assessed by the orthogonal experimental method.The value of BHF of 20KN,punching speed of 2000mm/s and clearance between punch and die of 1.1 mm which are the optimized parameters value are obtained.

关键词： Cylinder part Numerical simulation Dynaform software Orthogonal test

作者: Zehao Hu Juan Liu Nan Wang

作者单位: Department of Materials Forming, Central South University of Forestry and Technology, Changsha 410004, Hunan, China

会议类型: 国际会议

会议名称: the 2012 International Conference on Frontiers of Mechanical Engineering and Materials Engineering (机械工程与材料工程国际会议())

会议地点: 香港

会议语种:英文

页码: 337-340

在线出版日期: 2012-07-27（万方平台首次上网日期，不代表论文的发表时间）