Influence of Injection Velocity on Morphology and Fraction of Solid Phase During Thixomolding Process

摘要：

　　During Thixomolding process,solid phase fraction decreased with the injection velocity increasing.Meanwhile,the solid phase morphology changed from irregular dendrite to near spherical.Friction heat produced by high speed melt flow could cause partial melt of solid phase,and the morphology of solid phase would form into globular.The dendritic solid phase can be broken by high speed melt flow under the condition of injection velocity higher than 2.0m/s.

关键词： Magnesium alloy Semisolid Solid phase transformation Thixomolding

作者: Xiaopeng Cui Haiying Xu Haifeng Liu Tao Zhang Yongbing Liu

作者单位: Department of Materials Science and Engineering of Changchun University of Technology,the Key Labora R&D Centre of Foundry Corporation,FAW Group Corporation,Changchun,130062,P.R.of China Department of Materials Science and Engineering of Jilin University,the Key Laboratory of Automobile

会议类型: 国际会议

会议名称: the 2012 2nd International Conference on Frontiers of Manufacturing Science and Measuring Technology (第二届制造科学与检测技术国际会议(ICFMM 2012))

会议地点: 西安

会议语种:英文

页码: 90-94

在线出版日期: 2012-06-12（万方平台首次上网日期，不代表论文的发表时间）