Based on the ANSYS of small and deep hole a bit cutting transient dynamic study

摘要：

　　Introduces the general twist drill analysis,Through the continuous experiment and practice,obtained some processing key question method.As a result of small and deep hole parts of the scene processing efficiency is low,the improper selection of cutting quantity will cause premature wear of cutting tool.The traditional method is the empirical method and experimental method to solve the waste of material and time comparison.This article mainly is the finite element analysis software,the analysis of the ordinary drill thermal stress,transient dynamics,to solve the optimization of cutting parameters before processing,improve processing efficiency,save cost.

关键词： Deep hole drilling Finite element analysis Drilling process Transient dynamic

作者: Ping Wei Jiang Han Huilian Geng

作者单位: Anhui Techinical College of Mechanical and Electrical Engineering,China HeFei University of Technology,China

会议类型: 国际会议

会议名称: the 2012 2nd International Conference on Frontiers of Manufacturing Science and Measuring Technology (第二届制造科学与检测技术国际会议(ICFMM 2012))

会议地点: 西安

会议语种:英文

页码: 802-804

在线出版日期: 2012-06-12（万方平台首次上网日期，不代表论文的发表时间）