Research on Rubber One Step Injection Molding Technology and Equipment

摘要：

　　Through the laboratory research on the one step injection molding technology,as well as a series of industrialization researches on the injection tire capsule,injection oilfield used screw drill rubber stator and injection solid tire,this thesis presents the principle of one step injection molding technology and proves the feasibility,practicability of this technology.Substituting the traditional compression molding method,one step injection molding is a new technology with high efficiency,good product quality and low cost; it also has a broad prospect of application and huge developing potential.

关键词： one step injection molding tire capsule screw drill rubber stator solid tire research

作者: Yizhou Pei Baiyuan Lv

作者单位: College of Electromechanical Engineering,Qingdao University of Science and Technology,Qingdao 266042,P.R.China

会议类型: 国际会议

会议名称: the Asian Workshop on Polymer Processing 2011(2011高分子加工技术亚洲研讨会(AWPP2011))

会议地点: 青岛

会议语种:英文

页码: 344-348

在线出版日期: 2011-11-04（万方平台首次上网日期，不代表论文的发表时间）