The New Method In Scraping The Back Off Surface Of Side Edge Of The Carbide Hob

摘要：

　　The paper determines the shape of grinding wheel by the contact condition,not by the cutting edges,and introduced the NC grinding.After regrinding the cutting edge has at least 2 points coincided with the theoretical edge,even after regrinding for many times.So that increased the length of regrinding of the hob.

关键词： Hob scraping NC control

作者: Liu Hu ran

作者单位: Dept.of mechanical engineering,Zhejiang University of Science and Technology,Hangzhou 310023

会议类型: 国际会议

会议名称: the international conference on Frontier of Nanoscience and Technology (2011纳米科学与技术国际会议(ICFNST 2011))

会议地点: 大理

会议语种:英文

页码: 754-759

在线出版日期: 2011-08-18（万方平台首次上网日期，不代表论文的发表时间）