The Development of Metal Injection Moulding for ZK60 Magnesium Alloy using Palm Stearin Based Binder System

摘要：

　　In this paper,the development of green compact of ZK60 magnesium alloy was studied in the context of MIM using screw type injection moulding machine model Battenfeld BA250CDC.The MIM feedstock used was 64 vol.% powder loading and the balance was palm stearin and low linear density polyethylene with the fraction of 60/40 by weight percent.The injection moulding parameters were then adjusted until the optimal condition of green part was accomplished.Results indicate that the feedstock exhibited good workability when injection moulded at the temperature of 190 C,injection pressure of 900kN,flow rate of 15,5cm3/s and with a very low ejection parameters.This technique provides an additional means to manufacture magnesium alloy components for a wide variety of applications.

关键词： Metal injection moulding magnesium alloy injection moulding parameters

作者: M.R.Harun N.Muhamad A.B.Sulong N.H.Mohamad Nor K.R.Jamaludin

作者单位: Department of Mechanical & Materials Engineering, Faculty of Engineering & Built Environment,Univers Department of Mechanical & Materials Engineering, Faculty of Engineering & Built Environment,Univers Department of Mechanical & Materials Engineering, Faculty of Engineering & Built Environment,Univers City Campus, Universiti Teknologi Malaysia, Jalan Semarak, 54100 Kuala Lumpur, Malaysia

会议类型: 国际会议

会议名称: the 2011 International Conference on Frontiers of Manufacturing Science and Measuring Technology (第一届制造科学与检测技术国际会议(ICFMM2011))

会议地点: 重庆

会议语种:英文

页码: 1199-1203

在线出版日期: 2011-06-23（万方平台首次上网日期，不代表论文的发表时间）