Research on The Wire Drawing Die Pass Parameter Calculation Based on The Least Square Algorithm
Drawing Dies meter A / D acquisition module will be collected from the mold hole contour data to draw a curve in Matlab.According to the mold pore structure characteristics of the curve,the initial cut-off point of each part of contour is determined and iteratived optimization to find the best cut-off point,use the least squares method for fitting piecewise linear and fitting optimization to find the function of the various parts of the curve function,fmally calculate the pass parameters of drawing mode.Parameters obtained compare with the standard mold,both of errors are relatively small that prove the correcmess of the algorithm.Also a complete algorithm flow of pass parameters is designed,it can fast and accurately measure the wire drawing die hole parameters.
Wire Drawing Dies MATLAB Least Square Method Piecewise Linear Approximation
Huai Xing Wen Yong Tao Yang
College of Mechanical & Electrical Engineering Mailbox845,Shaan Xi University of Science &Technology,Xi an,710021,China
国际会议
广州
英文
850-853
2012-11-16（万方平台首次上网日期，不代表论文的发表时间）