Fabrication and properties of poly(ether imide)/poly(vinyl alcohol) composite ultrafiltration membrane

摘要：

　　A poly(ether imide) (PEI) composite membrane was prepared by dip coating a PEI membrane pretreated with 2-aminoethanole (AEOH) into an aqueous solution of poly(vinyl alcohol) PVA and glutaraldehyde (GA).PEI membrane support was firstly prepared via phase inversion technique by casting a solution of PEI in N-methylpyrrolidone (NMP),using water as non-solvent.The hydrophilicity,permeability,anti-fouling and mechanical properties of unmodified PEI and PEI/PVA composite membranes were investigated.By comparison with the unmodified PEI membrane,the PEI/PVA composite membrane exhibited a higher pure water flux and an increase in its hydrophilicity.In addition,the flux recovery of the pure water flux of the composite PEI membrane was higher than that of the unmodified PEI membrane.This indicated that the obtained composite membrane could reduce the membrane fouling and improve its use for ultrafiltration.

关键词： Poly(ether imide) Composite Membrane Ultrafiltration Fouling

作者: Watchanida Chinpa

作者单位: Department of Materials Science and Technology, Faculty of Science, Prince of Songkla University Hat-Yai, Songkhla, Thailand 90112

会议类型: 国际会议

会议名称: the 2012 International Conference on Materials Science and Nanotechnology (2012年材料科学与纳米技术国际会议(ICMSN 2012))

会议地点: 广州

会议语种:英文

页码: 18-21

在线出版日期: 2012-11-16（万方平台首次上网日期，不代表论文的发表时间）