Simulation and Analysis on the Molding Pressure Roller of Lead Flake Based on AMESim and ADAMS

摘要：

　　In this paper,introduced the structure and speed control principle which are the molding pressure roller of lead flake.Then,the co-simulation technology of AMESim and ADAMS is used to build a mechanical model of the molding pressure roller in ADAMS and build the model of hydraulic system and separation algorithm of PID controller in AMESim.Finally,according to the co-simulation model to analyse the molding pressure roller of lead flake in AMESim simulation interface.Simulation results show that the design of speed control system has good dynamic performance.

关键词： Molding pressure roller ADAMS AMESim Co-simulation PID

作者: Rong Li Jing Luo Zu-shun He Zhi-fei Peng

作者单位: Institute of Optical Hydromechatronics System Integration and Control Engineering,Faculty of Mechanical and Electrical Engineering,Kunming University of Science and Technology,Kunming 650093,China

会议类型: 国际会议

会议名称: the 16th International Conference on Fluid Dynamic and Mechanical & Electrical Control Engineering (第16届流体动力与机电控制工程国际学术会议 (FDMECE2012))

会议地点: 重庆

会议语种:英文

页码: 114-118

在线出版日期: 2012-11-10（万方平台首次上网日期，不代表论文的发表时间）