Optimization of Injection Molding Process Parameters Based on Taguchi Design of Experiment

摘要：

　　In this paper,circulating box cover is taken as the main object of the study with the application of Taguchi design of experiment and Moldflow software.The warpage deformation was obtained under different molding conditions including melt temperature,mold temperature,filling time and packing time.The influencing degree and trend of these parameters was studied by using the rang analysis,and the optimization set of factors was obtained.Experimental results show that the optimization design is effective and the warpage of the product reduce.

关键词： injection molding taguchi design of experiment warpage optimiazation

作者: Xuefeng Li Hongbin Liu

作者单位: Faculty of Mechanical and Electrical Engineering,Kunming University of Science and Technology,Kunming,Yunnan 650500,China

会议类型: 国际会议

会议名称: the 16th International Conference on Fluid Dynamic and Mechanical & Electrical Control Engineering (第16届流体动力与机电控制工程国际学术会议 (FDMECE2012))

会议地点: 重庆

会议语种:英文

页码: 335-338

在线出版日期: 2012-11-10（万方平台首次上网日期，不代表论文的发表时间）