Research on optimal cutting parameters of High-Speed hard Machining based on the Principal Component analysis and Taguchi method

摘要：

　　The optimization of the parameters in high-speed milling was analyzed based on the principal component analysis and the Taguchi method.The cutting speed,feed per tooth and cutting depth were selected as the cutting parameters while the cutting force,cutting power and surface roughness parameters were selected as quality characteristics.The optimum cutting parameters were obtained and the comprehensive quality of high-speed hard machining has been guaranteed.

关键词： High-speed hard machining Taguchi method Principal Component analysis method

作者: Wenhui Cao Hongbin Liu Shensong Wang Ting Yang

作者单位: Faculty of Mechanical and Electrical Engineering,Kunming University of Science and Technology,Kunming,Yunnan Province,China 650500

会议类型: 国际会议

会议名称: the 16th International Conference on Fluid Dynamic and Mechanical & Electrical Control Engineering (第16届流体动力与机电控制工程国际学术会议 (FDMECE2012))

会议地点: 重庆

会议语种:英文

页码: 343-346

在线出版日期: 2012-11-10（万方平台首次上网日期，不代表论文的发表时间）