Study on the Design of Corner Conveyor Driven by V Belt with Friction
Comer conveyor is widely applied in all kinds of automatic transmission line,and it is the most important member in the family of conveyors.To improve the product quality and the precision of the comer conveyors,in addition to control strictly the production techniques and monitor its manufacturing process,the most important is to improve the design level and the design efficiency.In this paper,a new type of corner conveyor driven by V belt with friction will be studied by usingSolid Edge ST4 3d synchronous modeling technology.In the process of design,synchronous modeling,parallel design,modular design technology and top-down assembly modeling technology are combined with in the design of comer conveyor.With modular ideas for design to consider the overall structure of design scheme,design will turn into different parts of conveying design module to consider,and promote the standardization of product design.The key point in this paper is that synchronous modeling technology is used in the three dimensional modeling of comer conveyor,and shows that the technology in different modules and the cooperation between different designers.The results show that the application of the technology can reduce iterative design process and design error,thus the design efficiency of engineer is greatly improved.
V belt with friction Synchronous Technology Corner Conveyor Top-down Assembly Modeling technology Module design
Xuejun Wang Yilin Chi Li Gao
Faculty of Mechanical & Electrical Engineering,Kunming University of Science & Technology,253 Xue Fu Faculty of Graduate,Kunming University of Science & Technology,253 Xue Fu Road,Kunming,650093,P.R.Ch
国际会议
重庆
英文
351-354
2012-11-10（万方平台首次上网日期，不代表论文的发表时间）