Influence of Die-punch Gap to Hot Stamping Quality of A Door Anti-collision Beam

摘要：

　　By study on die-punch gap of hot stamping mold for a door anti-collision beam,it was obtained that,when the gap was designed,not only thermal expansion of steel plate but also that of die and punch should be considered.Through simulation and experiments about influence of the gap to hot stamping quality,the following results were obtained that,too great or too small of the gap would lead to much greater of thinning rate and stress,the reasonable gap of die for door anti-collision beam was 1.1~1.2 times of steel plate thickness.

关键词： Hot stamping die gap of male and female die stamp thinning

作者: Zhang Milan Shan Zhongde Jinag Chao Zhagn Min Xu Ying Zhang ZhenState

作者单位: Key Laboratory of Advanced Forming Technology and Equipment, Advanced Manufacture Technology Center, China Academy of Machinery Science & Technology, 100083, Beijing

会议类型: 国际会议

会议名称: 2012 Postdoctoral Symposium of China on Materials Science & Engineering -- Advanced Materials for Sustainable Development (2012 年中国博士后材料科学与工程学术论坛--先进材料与可持续发展)

会议地点: 上海

会议语种:英文

页码: 232-232

在线出版日期: 2012-10-19（万方平台首次上网日期，不代表论文的发表时间）