Study On Flute Design For End Mill Based On Oblique Cutting Model

摘要：

　　Aimed at the design of the radius of flute for solid carbide end mill,a new oblique cutting model for milling was established based on the simplified model of milling layer.Depending on this model,an equation was developed to calculate the maximum chip thickness in milling.An oblique cutting simulation via FEM(Finite Element Method) was conducted to verify the equation.The conclusion was that the result gained from the simulation was in a good agreement with the present model,so the present model is reasonable to predict the maximum chip thickness in milling and to determine the radius of the arc at the bottom of the tinte.

关键词： End mill Radius of flute Oblique cutting FEM

作者: Guangcun Wang Jianfeng Li Jie Sun Fangyi Li

作者单位: Department of Mechanical Engineering, Shandong University, Jinan, 250061, Shandong, China

会议类型: 国际会议

会议名称: the Second International Conference on Frontiers of Manufacturing and Design Science(第二届制造与设计科学国际会议(ICFMD 2011))

会议地点: 台湾

会议语种:英文

页码: 4758-4763

在线出版日期: 2011-12-11（万方平台首次上网日期，不代表论文的发表时间）