Influence of the Dispersant on the Bead Milling of Alumina

摘要：

　　The high-pure alpha-alumina powders with some agglomerate were treated by bead milling and their sintering behaviors were studied in this paper.During the treatment,the effect of different types and different amounts of dispersants was also investigated.It was shown that optimum dispersant content was 0.5% citric acid and optimum milling time is 6 hours.The sintering property of alumina powder after bead milling was significantly improved.Their relative density after sintering at 1500 degrees can reach 99.3% while the raw powders can only reach 90% at the same condition.

关键词： bead milling dispersant sintering alumina

作者: Ling Yuan Longhao Qi Wei Pan

作者单位: State Key Laboratory of New Ceramics and Fine Processing,Department of Materials Science and Engineering,Tsinghua University,Beijing 100084,P.R.China

会议类型: 国际会议

会议名称: The Seventh China International Conference on High-Performance Ceramics (第七届先进陶瓷国际研讨会(CICC-7))

会议地点: 厦门

会议语种:英文

页码: 36-39

在线出版日期: 2011-11-04（万方平台首次上网日期，不代表论文的发表时间）