Deformation Characteristics of ultra-fine grained Al6061 chip in machining by Finite Element Method
Ultra-fine grained chips with higher hardness and strength than bulk can be produced by severe plastic deformation during orthogonal metal cutting.A finite element method was developed to characterize the distribution of stress,strain,strain rate and temperature in the deformation area at different rake angles and cutting velocities.The coefficient of friction in the tool-chip interface is approximately obtained according model of mean coefficient of friction which is based on experiments in any machining conditions.The formation mechanics of ultra-fine grained chip is discussed and effect of rake angle on microstructure of chips is highlighted.The results of experiment and modeling have shown that chip materials with ultra-fine grained and high hardness can be produced with more negative tool rake angle at some lower cutting velocity.
ultra-fine grained chip large strain deformation Al6061 finite element method TEM
C.L.Wu B.Y.Ye
School of Mechanical and Automotive Engineering, Xiang Fan University, Xiangfan, China School of Mechanical and Automotive Engineering, South China University of Technology,Guangzhou, Chi
国际会议
重庆
英文
2931-2934
2010-12-11（万方平台首次上网日期，不代表论文的发表时间）