Preparation and Releasing Characteristics of Controlled Release Potassium Permanganate
To extend the duration of KMnO4 in the groundwater in situ remediation,controlled release oxidant was prepared by dispersing the KMnO4 particles in the molten paraffin wax.Preparation conditions,including KMnO4 particles size,ultrasonic treatment time and the weight ratio of KMnO4 to wax (P/W) were optimized.The results showed that the average volume particle size of 13.20 μm and ultrasonic treatment of 10 min contribute to the most uniform dispersion of the KMnO4 particles in the molten paraffin wax.The scanning electron microscope (SEM) images showed that the increased amount of KMnO4 caused the crushed structure of paraffin wax,which resulted in the higher porosity of wax to contain more KMnO4.The KMnO4 loading amount increased significantly along with the increase of the P/W.However,the loading amount almost reached saturation by 609.63 mg/g when the P/W increased to 2/1.The releasing characteristics of the samples in the distilled water and the KMnO4 residual amount at different radial distance in the sample were examined by the bench scale tests.The releasing of KMnO4 could be divided into four periods and stable release took place after 40 d.Controlled release KMnO4 oxidant with P/W at 1/35 was used to remove COD in the leachate and 82.9% removal efficiency was obtained after 120 d treatment.
Potassium permanganate Controlled release Load amount Leachate
Shuangshi Dong Jin Wang Yanlong Wang Jianbin Zhang Dandan Zhou Chunyan Shao
Key laboratory of Groundwater and Environment, Ministry of Education, Jilin University, Changchun 130021, China
国际会议
the Chinese Materials Congress 2012(2012年中国材料大会(CMC2012))
太原
英文
782-788
2012-07-13（万方平台首次上网日期，不代表论文的发表时间）