Establish of dynamic recrystallization model of XC45 steel

摘要：

Hot compression tests were carried by using a Gleeble-1500 thermo-mechanical simulator to obtain the flow stress-strain curves of XC45 steel under different deformation conditions. The dynamic recrystallization model of XC45 steel was established by calculation. The validity of dynamic recrystallization mode was verified by comparing numerical simulation results, calculated values of model and experimental results. It indicates that the calculated values of model and numerical simulation results are consistent with experimental results. The values of dynamic recrystallization volume fraction and grain sizes increase with increasing deformation temperature at the same strain rate; and the values of dynamic recrystallization volume fraction and grain sizes decrease with increasing strain rate at the same deformation temperature.

关键词： XC45 steel dynamic recrystallization model numerical simulation

作者: CHAI Rongxia YU Li GUO Cheng

作者单位: Department of Mechanical Engineering,Xian Jiaotong University,Xian 710049,China Norinco North General Electronic Group Co.,Ltd.,Xian 710100,China

会议类型: 国际会议

会议名称: The 12th Asian Symposium on Precision Forging 第12届亚洲精密锻造学术研讨会 ASPF2012

会议地点: 苏州

会议语种:英文

页码: 68-72

在线出版日期: 2012-10-21（万方平台首次上网日期，不代表论文的发表时间）