会议专题

Gear tooth profile optimization of pre-forging straight bevel gear

Hot and cold compound forging process was selected to produce straight bevel gear. The importance of preforging gear tooth profile was stated. AFDEX-3D software was used to simulate the cold sizing process. After analyzing the simulate results and process experiments, the advantages and disadvantages of equidistant and non-equidistant gear profiles were summed up. Using equidistant tooth profile, fold defect would exist if the cold sizing amount was large, while the roughness of tooth surface was bad if cold sizing amount was small. Using nonequidistant tooth profile, which increase the meshing region sizing amount and decrease the root sizing amount, the defect disappeared. Through comparing the results, it was found that the non-equidistant preforging gear tooth profile was better than equidistant.

straight bevel gear pre-forging gear tooth profile simulation process experiment

QIU Dehua BIAN Yi HUANG Xina QI Pengfei

Beijing Research Institute of Mechanical & Electrical Technology,Beijing 100083,China

国际会议

The 12th Asian Symposium on Precision Forging 第12届亚洲精密锻造学术研讨会 ASPF2012

苏州

英文

156-160

2012-10-21(万方平台首次上网日期,不代表论文的发表时间)