Analysis of cutting zone machinability during the drilling of XCM8Ni8 stainless steel

摘要：

This paper presents the conclusions of machinability tests on a XCrl8Ni8 stainless steel. The content of this article also focuses on the analysis of selected basic indicators of steel machinability: quality of the processed surface. The results of the article are conclusions for working theory and practice for drillng of austenitic stainless steels. Based on the cutting tests, cutting speeds of 40 to 60 m/min, feed rate of 0.04 to 1.2 mm and screw drill carbide monolite.

关键词： drilling cutting zone plastic deformation steel XCr18Ni8 machinability

作者: Jozef Jurko Anton Panda Marcel Behún

作者单位: Vacuity of Manufacturing Technologies Technical University in Kosice with seat in Presov,Department of Production Technology, Slovak Republic

会议类型: 国际会议

会议名称: 2012 International Conference on Industiial Design and Mechanical Power(2012工业设计与机械动力国际会议 ICIDMP 2012)

会议地点: 黄山

会议语种:英文

页码: 142-145

在线出版日期: 2012-07-10（万方平台首次上网日期，不代表论文的发表时间）