The use of TiAIN coated carbide tool when finish machining stainless steel

摘要：

This article presents conclusions of use TiAIN at drilling of a new austenitic stainless steels. This article presents the results of experiments that concerned the verification of the cutting tool wear. The results of cutting zone evaluation under cutting conditions (cutting speed vc=60 m/min, depth of cut ap= 3.0 mm and feed f= 0.04 mm per rev.).

关键词： Tool wear Coated Carbide Drilling Cutting Tool Stainless Steel

作者: Jozef Jurko Anton Panda Marcel Behun

作者单位: Faculty of Manufacturing Technologies Technical University in Kosice,Department of Manufacture Technology, Slovak Republic

会议类型: 国际会议

会议名称: 2012 International Conference on Industiial Design and Mechanical Power(2012工业设计与机械动力国际会议 ICIDMP 2012)

会议地点: 黄山

会议语种:英文

页码: 204-207

在线出版日期: 2012-07-10（万方平台首次上网日期，不代表论文的发表时间）