Study on Minimum Teeth without Undercutting of the Stub Tooth Involute Gears Based on VB
Based on the principle of gear generating, theoretical research and VB software simulation about undercut are presented in this paper. The rack cutter is used to infer minimum teeth without undercutting of stub tooth involute gear, stub tooth helical gear and stub tooth straight bevel gear. And, which are respectively analyzed and calculated. Thus, correct minimum teeth without undercutting are got; theoretical analysis and calculation on the involute stub tooth gear have been carried out. Then, minimum teeth without undercutting can be obtained, and use VB software to carry on simulation for verifying the validity of the theoretical calculation.
gear generating method stub tooth spur gear VB undercutting minimum teeth
Jianing He Yong Gao Haibin Zhang Wei Zhang Chao Zhang
Faculty of Mechanical and Electrical Engineering Kunming University of Science and Technology Kunming 650093, China
国际会议
杭州
英文
80-83
2012-03-23（万方平台首次上网日期，不代表论文的发表时间）