The purpose of this study is to quantitatively evaluate behaviors of ash deposition during combustion of Upgraded Brown Coal (UBC) and bituminous coal in a 145 MW practical coal combustion boiler.A blended coal consisting 20 wt％ of the UBC and 80 wt％ of the bituminous coal was burned for the combustion tests.Before the actual ash deposition tests,the molten slag fractions of ash calcualted by chemical equilibrium calculations under the combustion condition was adopted as one of the indices to estimate the tendency of ash deposition.The calculation results showed that the molten slag fraction for UBC ash reached approximately 90％ at 1523 K.However,that for the blended coal ash became about 50％.These calculation results mean that blending the UBC with a bituminous coal played a role in decreasing the molten slag fraction.Next,the ash deposition tests were conducted,using a practical pulverized coal combustion boiler.A water-cooled stainless-steel tube was inserted in locations at 1523 K in the boiler to measure the amount of ash deposits.The results showed that the mass of deposited ash for the blended coal increased and shape of the deposited ash particles on the tube became large and sperical.This is because the molten slag fraction in ash for the blended coal at 1523 K increased and the surface of deposited ash became sticky.However,the mass of the deposited ash for the blended coal did not greatly increase and no slagging problems occurred for 8 days of boiler operation under the present blending conditions.Therefore,appropriate blending of the UBC with a bituminous coal enables the UBC to be used with a low ash melting point without any ash deposition problems in a practical boiler.
Slagging Ash deposition Upgraded Brown Coal (UBC) Coal combustion boiler
Katsuya Akiyam Haeyang Pak Yoji Takubo Toshiya Tada Yasuaki Ueki Ryo Yoshiie Ichiro Naruse
Mechanical Engineering Research Laboratory,KOBE TEEL,LTD.,Kobe,651-2271,JAPAN Mechanical Engineering Research Laboratory,KOBE STEEL,LTD.,Kobe,651-2271,JAPAN Coal and Energy Technology Department,KOBE STEEL,LTD.,Takasago,676-8670,JAPAN Energy Science Division,EcoTopia Science Institute,NAGOYA UNIVERSITY,Nagoya,464-8603,JAPAN Department of Mechanical Science & Engineering,NAGOYA UNIVERSITY,Nagoya,464-8603,JAPAN Department of Mechanical Science & Engineering,NAGOYA NIVERSITY,Nagoya,464-8603,JAPAN