Cutter Path Optimization during High-speed Machining of Numerical Control

摘要：

During the high-speed machining, cutter path of numerical control needs to satisfy the following requirements.There has no colliding among work pieces, fixtures and so on.The cutter path variation cannot too dramatically and the vibration should in the controlled area during the process.Feed speed can modify with path curvature variation and cutting depth need to be equality.This article will analyze and research in the mode of cutter advanced and retreats, cutter movement mode, cutter feed mode and cutter path of corner treatment during the high-speed process programming that could effective optimize cutter path, process efficiency and quality.

关键词： high-speed machining programming cutter path optimization

作者: Yongxiang Gao

作者单位: School of Mechanical Engineering,ZheJiang Institute of Mechanical and Electrical Engineering Hangzhou,China 310053

会议类型: 国际会议

会议名称: 2011 2nd International Conference on Material and Manufacturing Technology(2011第二届材料与制造技术国际会议 ICMMT2011)

会议地点: 厦门

会议语种:英文

页码: 318-322

在线出版日期: 2011-07-08（万方平台首次上网日期，不代表论文的发表时间）