Rough Turning of Titanium Alloy (6Al-4V)
Metal machining is the complex process due the used cutting parameters. In metal cutting process,materials of workpiece differ widely in their ability to deform plastically, to fracture and to sustain tensile stresses. Moreover, the material involved in the process has a great influence in these operations.The Ti-6Al-4V alloy is very used in the aeronautical industry,mainly in the manufacture of engines,has very important properties such the mechanical and corrosion resistance in high temperatures. The turning of the Ti-Al-4V alloy is very difficult due the rapid tool wear. Such behavior result of the its low thermal conductivity in addition the high reactivity with the cutting tool. The formed chip is segmented and regions of the large deformation named shear bands plows formed. The machinability of the cutting process can be evaluated by several measures including power consume,machined surface quality, tool wear,tool life,microstructure and morphology of the obtained chip. This paper studies the effect of cutting parameters,speed and feed rates,in the tool wear and chip properties using uncoating cemented carbide tool. Microe-structural characterization of the chip and tool wear was performed using scanning electron microscopy (SEM) arid Light Optical Microscopy (LOM).
Titanium (Ti) machining shear band wear
Marcos V. Ribeiro Marcos R. V. Moreira Jo(a)o R. Ferreira
Department of Materials and Technology,Univ. Estadual Paulista - UNESP,Guaratingueld/SP,12516-410,Br Department of Materials Engineering,EEL-USP,Lorena/SP,12602-810,- Brazil Department of Production Engineering,UNIFEI,Itajubd/MG,37500-000,Brazil
国际会议
The 12th World Conference Titanium(第十二届世界钛会 Ti-2011)
北京
英文
1961-1964
2011-06-19（万方平台首次上网日期，不代表论文的发表时间）