会议专题

A Nanosecond High Voltage Impluse Protector for small signal measurement device

In high voltage partial discharge experiments, the partial discharge measurement device is in the risk of fast transient high voltage because of insulation sample breakdows. An protector is designed based on the gas discharge tube and switching diode to protect the measurement devices. The frequency spectrum of the protector was measured by square signal and sine wave signal. Its protection capability were proved by nanosecond high voltage impulse, high voltage lightning impulse, and oil insulation breakdown trans instantaneous high voltage. The test results showed that the protector has wide frequency beyond 80MHz. And the outage voltage fo the protector can be limited to 2V even if its input come up to 30kV and less than 5ns.

High Voltage Input Protector Discharge Tube Switching Diode

Yan Yinghui Chen Ming Cheng Yangchun Kong Jianliang Ji Hongxin Song Anqi

Beijing Key Laboratory of High Voltage and EMC,North China Electric Power University,Beijing 102206,China

国际会议

2012 International Conference on Intelligent System Design and Engineering Applications(2012年智能系统设计与工程应用国际会议 ISDEA 2012)

三亚

英文

1359-1362

2012-01-06(万方平台首次上网日期,不代表论文的发表时间)