The Method and Technique of 2D Drawing Creation Based on NX7.5

摘要：

The method and technique of the 3D model transformation for 2D engineering drawing using NX7.5 was studied. The key points of GC china toolkits, method of master model and pattern were introduced. The GC china toolkits produced convenient way to custom drawing standard to match China standard through some simple operation. The method of master model realized the relativity between 3D model and 2D drawing. The pattern was an effective method to add drawing frame and title bar to sheets. In the end, the process of 2D engineering graphics creation was expatiated. The practice case proves that the drawing efficiency is improved greatly by NX7.5 application.

关键词： NX 2D drawing Master model Pattern

作者: Xianghui Zhan Xiaoda Li

作者单位: Department of Mechanical and Electrical Engineering, Zhuhai College of Jilin University, China

会议类型: 国际会议

会议名称: 2011 International Conference on Mechatronics and Applied Mechanics(2011年机电一体化与应用力学国际会议 ICMAM 2011)

会议地点: 香港

会议语种:英文

页码: 119-122

在线出版日期: 2011-12-27（万方平台首次上网日期，不代表论文的发表时间）