Research on Structure Analysis of a Feeder Based on ANSYS

摘要：

Based on the large analysis software ANSYS, the FEA model of feeder was be setted up, the mechanical properties of the material was considered ,and the stress and deformation under loaded of two type materials HDPE and LDPE were be Comparative analysied, Results show that: the funnels stress smaller,the maximum stress only 2-3Mpa and no more than 7-31Mpa of two materials tensile strength.The funnels deformation in allowing strain range about 2-3 mm, so structure is safe.In addition,the feeder legs bearred bigger force about 60Mpa, because the material was used Q345 steel, so the strength was enough and HDPE material feeder have leeway of reduced materials.

关键词： Ansys Feeder Mechanical properties

作者: Yan yan ZHANG Ming ming ZHU

作者单位: Huanghe Science And Technology University, Zhengzhou 450093, China Henan Entry-Exit Inspection and Quarantine Bureau, Zhengzhou 450003,China

会议类型: 国际会议

会议名称: 2011 International Conference on Mechatronics and Materials Processing(2011年机电一体化与材料加工国际会议 ICMMP)

会议地点: 广州

会议语种:英文

页码: 610-613

在线出版日期: 2011-11-18（万方平台首次上网日期，不代表论文的发表时间）