Finite Element Analysis and Experimental of Milling Force for Aeronautical Thin-walled Workpiece

摘要：

Traveling load and rotating load can be applied to the tool on the basis of analyzing the relative position between tool and workpiece in assemble model of finite simulation, a finite element model based on trochoid-motion is built. In order to reduce the simulation time, the transition mesh method was used to optimize the finite element model. This paper considers performance parameter of the workpiece, and studied the variation regularities of milling force on the Aeronautical thin-walled by using ABAQUS. At last the experiment shows that the finite element model was verified to be feasible, and the result is reliable.

关键词： Trochoid Milling Force FEM Simulation Aeronautical thin-walled Experiment

作者: Jin Yu Yu Xiang Shi Gui Wu Yang

作者单位: School of Electromechanical Engineering, Shenyang Aerospace University, Shenyang, 110136,China

会议类型: 国际会议

会议名称: 2011 International Conference on Mechatronics and Materials Processing(2011年机电一体化与材料加工国际会议 ICMMP)

会议地点: 广州

会议语种:英文

页码: 685-689

在线出版日期: 2011-11-18（万方平台首次上网日期，不代表论文的发表时间）