Plastic Micro Features Produced by Microwelding Machine

摘要：

The method of using microwelding machine to fabricate micro features on a stainless steel micro mould has been studied. The micro features obtained from molding using an ultrasonic microwelding machine have shown distinctive characteristics. The microflow behavior of polymer melt during the microwelding process is also studied. The micro molds of 0.2mm thick and through holes of 0.05mm and 0.2mm in diameters were used. Results show micro features can be produced using the microwelding machine with molding speed comparable to that of micro injection molding.

关键词： micro feature microwelding micro molding

作者: H. Liu Y. Xu K.L. Yung C.L. Kang W. Tian

作者单位: Department of Industrial & Systems Engineering, The Hong Kong Polytechnic University, Hung Horn, Kow Department of Industrial & Systems Engineering, The Hong Kong Polytechnic University, Hung Horn, Kow

会议类型: 国际会议

会议名称: 2011 International Conference on Mechatronics and Materials Processing(2011年机电一体化与材料加工国际会议 ICMMP)

会议地点: 广州

会议语种:英文

页码: 1453-1456

在线出版日期: 2011-11-18（万方平台首次上网日期，不代表论文的发表时间）